• Home
  • Alternate Flange Facings

Alternate Flange Facings

Large Male and Female

Lap Joint

Small Tongue and Groove

Small Male and Female

Small Male and Female on end of pipe

Raised Face

Large Tongue and Groove

Nominal Size        (in.)RF, LJ, Large Male and Large TongueSmall Male      (3)Small TongueID of Large and Small TongueLarge Female and Large GrooveSmall Female (3)Small GrooveID of Large and Small GrooveRaised Face 150 and 300 Pound Standards (2)RF, Large and Small Male and Tongue 400, 600, 900, 1500, & 2500 lb. Standards (2)Depth of Groove or Female
TUWXYZ
 1/21.380.721.3811.440.781.440.940.060.250.19
 3/41.690.941.691.311.7511.751.250.060.250.19
121.191.881.52.061.251.941.440.060.250.19
1 1/42.51.52.251.882.561.562.311.810.060.250.19
1 1/22.881.752.52.122.941.812.562.060.060.250.19
23.622.253.252.883.692.313.312.810.060.250.19
2 1/24.122.693.753.384.192.753.813.310.060.250.19
353.314.624.255.063.384.694.190.060.250.19
3 1/25.53.815.124.755.563.885.194.690.060.250.19
46.194.315.695.196.254.385.755.120.060.250.19
57.315.386.816.317.385.446.886.250.060.250.19
68.56.3887.58.566.448.067.440.060.250.19
810.628.38109.3810.698.4410.069.310.060.250.19
1012.7510.51211.2512.8110.5612.0611.190.060.250.19
121512.514.2513.515.0612.5614.3113.440.060.250.19
1416.2513.7515.514.7516.3113.8115.5614.690.060.250.19
1618.515.7517.6216.7518.5615.8117.6916.690.060.250.19
182117.7520.1219.2521.0617.8120.1919.190.060.250.19
202319.75222123.0619.8122.0620.940.060.250.19
2427.2523.7526.2525.2527.3123.8126.3125.190.060.250.19

Regular facing for 150 and 300 lb. Steel flanged fittings and flange standards is a 1/16 inch raised face included in the minimum flange thickness. A 1/16 inch raised face is also permitted on the 400, 600, 900, 1500, and 2500 Lb. Flange standards, but it must be added to the minimum flange thickness.

Regular facing for 400, 600, 900, 1500, and 2500 lb. Flange standards is a ¼ inch raised face not included in minimum flange thickness dimensions.

Care should be taken in the use of joints of these dimensions, (they apply particularly on lines where the joint is made on the end of pipe) to insure that pipe used is thick enough to permit sufficient bearing surface to prevent crushing the gasket. Threaded companion flanges are furnished with plain face and are threaded with American Standard Locknut Thread.